Broadcom Brocade X7-4 Director - Installing the Device in the Rack

X7-4-Install-IG100 Installation Guide Brocade
®
X7-4 Director Hardware Installation Guide
Figure 8: Securing Top Rail in Rack
1. Top Rail
2. Duct
3. 6-32 x .25 in. (.635 cm) Phillips Screws
4. 10-32 x .5 in. (1.27 cm) Phillips screws with blue Loctite on threads and alignment washers or 10-32
x .63 in.(1.60 cm) Phillips screw with square cone washer
Installing the Device in the Rack
1. If a door is installed on your chassis, ensure that it is removed. See the procedures for removing and replacing the
device door in this guide.
2. Use a hydraulic lift to raise the device to the correct level.
DANGER
Use safe lifting practices when moving the product.
X7-4-Install-IG100
35
Broadcom