X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
Figure 10: Airflow Diversion and Port-Side Exhaust Kit Assembly for 68.58 to 78.74 cm (27-31 in.) Racks
1. Top Rail
2. Duct
3. Shelf
4. 10-32 x .5 in. (1.27 cm) Phillips Screw with Blue Loctite on Threads
5. 10-32 x .63 in.(1.60 cm) Phillips Screw with Square Cone Washer (for racks that have rails with round holes)
6. 10-32 Clip Nut (for racks that have rails with round holes)
7. 10-32 Retainer Nut (for racks that have rails with square holes)
8. Alignment Washer (for racks that have rails with square holes)
9. 6-32 x .25 in. (.635 cm) Phillips Screw
Torque Requirements
Use the following torque settings when tightening screws that secure the rack mount kit and device to the equipment rack.
X7-4-Install-IG100
38
To Next Page
Loading...