X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
Figure 18: Using Clip Nuts and Retainer Nuts to Secure Screws to Rack Rails
1. Clip Nuts (for rails with round holes)
2. Retainer Nuts (for rails with square holes)
3. Rail
3. Remove any existing rack-mount brackets from the device, and install the new Telco mid-mount brackets from the
accessory kit. Refer to the following figure.
NOTE
The following figure shows mounting brackets from XBR-DCX4S-0126. Mounting brackets from the XBR-
X64-0126 kit install the same way.
X7-4-Install-IG100
47
To Next Page
Loading...