X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
6. Secure the device to the rack using six 10-32 screws with square-cone washers, three screws for each mounting
bracket attached to the device. Refer to the following figure. Tighten the screws to 36.86 cm-kg (32 in.-lb).
NOTE
Screws, clip nuts, and retainer nuts for mounting the device to the equipment rack are located in the device
hardware accessory kit.
Figure 21: Device Installed in Mid-Mount Saddle
1. 10-32 Screws with Square-Cone Washers (6)
NOTE
For rails with round holes, use the clip nuts on the rack rails for securing 10-32 screws. For rails with square
holes, use the retainer nuts.
X7-4-Install-IG100
50
To Next Page
Loading...