Broadcom Brocade X7-4 Director - Page 55

X7-4-Install-IG100 Installation Guide Brocade
®
X7-4 Director Hardware Installation Guide
6. Secure the device to the equipment rack racks with six 10-32 x .63 screws with square-cone washers, three screws on
each side. Tighten the screws to a torque of 92 cm-kg (80 in-lb). See the following figure.
Figure 26: Chassis Installed in Equipment Rack
1. 10-32 x .63 in. (1.60 cm) Phillips Screw with Square Cone Washer
7. Reinstall the device door. For instructions, see procedures for removing and replacing the device door in this guide.
X7-4-Install-IG100
55
Broadcom