X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
Table 16: Port Blade LED Descriptions
LED Purpose Color Status Recommended Action
Steady green The blade is operational. No action is required.Power
No light (LED is off) The blade is not powered on. Ensure that the blade is firmly
seated, with ejectors pushed in
fully to the center of the blade
and ensure that the captive
screw for each ejector is fully
tightened.
No light (LED is off) The blade is either healthy or
does not have power.
Verify that the power LED is on.
Steady amber The blade is faulty. Ensure that the blade is firmly
seated and check the status
by entering the slotShow
command. If LED remains
amber, consult the device
supplier.
Slow-flashing amber (on 2
seconds, then off 2 seconds)
The blade is not seated correctly
or is faulty.
Pull the blade out and reseat
it. If LED continues to flash,
replace the blade.
Status
Fast-flashing amber (on 1/2
second, then off 1/2 second)
Environmental range has been
exceeded.
Check for out-of-bounds
environmental conditions and
correct them.
Port has no incoming power, or
there is no light or signal carrier
detected.
Verify that the power LED is on,
check the transceiver and cable.
Polling is in progress. Allow 60 seconds for polling to
complete.
No light (LED is off)
The connected device is
configured in an offline state.
Verify the status of the
connected device.
Steady green The port is online (connected to
an external device) but has no
traffic.
No action is required.
Slow-flashing green (on 1
second, then off 1 second)
The port is online but
segmented, indicating a
loopback plug or cable or an
incompatible switch.
Verify that the correct device is
attached to the chassis.
Fast-flashing green (on 1/4
second, then off 1/4 second)
The port is in internal loopback
(diagnostic).
No action is required.
Flickering green The port is online, with traffic
flowing through the port.
No action is required.
Steady amber The port is receiving light or
signal carrier, but it is not online
yet.
Reset the port from the
workstation using the portable or
portCfgPersistentEnable
command.
FC port Status
Slow-flashing amber (on 2
seconds, then off 2 seconds)
The port is disabled due
to diagnostic tests or
the portDisable or
portCfgPersistentEnable
commands.
Reset the port from the
workstation using the
portDisable or
portCfgPersistentEnable
command.
X7-4-Install-IG100
87
To Next Page
Loading...