Broadcom Brocade X7-4 Director - Interpreting FC64-48 Port Blade Leds

X7-4-Install-IG100 Installation Guide Brocade
®
X7-4 Director Hardware Installation Guide
LED Purpose Color Status Recommended Action
Fast-flashing amber (on 1/2
second, then off 1/2 second)
The transceiver or port is faulty. Change the transceiver or reset
the switch from the workstation.
Alternating green/amber The port is beaconing. No action is required.
Interpreting FC64-48 Port Blade LEDs
See the following figure and table to interpret the LED patterns for the FC64-48 blade. The LED patterns temporarily
change during POST and other diagnostic tests.
Figure 41: FC64-48 Port Blade LEDs
1. Blade Power LED
2. Blade Status LED
3. Status LED for Upper FC port
4. Status LED for Lower FC port
The following table describes the port blade LED patterns and the recommended actions for those patterns.
X7-4-Install-IG100
88
Broadcom