X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
LED Purpose Color Status Recommended Action
Fast-flashing amber (on 1/2
second, then off 1/2 second)
The
transceiver or port is faulty.
Change the transceiver or reset
the switch from the workstation.
Alternating green/amber The port is beaconing. No action is required.
Interpreting FC32-64 Port Blade LEDs
See the following figure and table to interpret the LED patterns for the FC32-64 blade. The LED patterns temporarily
change during POST and other diagnostic tests.
Figure 42: FC32-64 Port Blade LEDs
1. Blade Power LED
2. Blade Status LED
3. Status LEDs for QSFP+ Ports
The following table describes the blade LED patterns and the recommended actions for those patterns.
NOTE
When the QSFP is operating in breakout mode, each of the four LEDs above the QSFP+ port indicates the
status of an individual breakout port. When the QSFP is operating in nonbreakout mode (Ethernet QSFPs only),
the primary port LED (leftmost LED) indicates the status of the single, unified QSFP port. For example, for a
40GbE QSFP in breakout mode, each of the four LEDs indicates the status of a 10GbE port. In nonbreakout
mode, the primary LED (leftmost LED) indicates the status of the unified 40GbE port.
The following table describes the blade LED patterns and the recommended actions for those patterns.
X7-4-Install-IG100
90
To Next Page
Loading...