Brocade Communications Systems FastIron X Series Software Update

show ipv6
interface
ve 2 debug
Brocade#show ipv6 int ve 400 debug
Interface ve 400 , Port 2065, addr c:0x263019d6, p:0x2a588300,
n:0x263886c6
Conf:
#Addr 1, enabled_conf 1, curr: enabled 1
port_enabled 1, port_is_up 0, mtu 1500, metric 1, redir 0
Address: 2000:400:400:400::3/64
LL address fe80:400::400:1
RUN:
Port 2065, EUI 205:ff:fe05:5/64, MAC 0005.0005.0005/6, #Addr 0
MC addr ff02::16, ref 1, valid 1
MC addr ff02::d, ref 1, valid 1
MC addr ff02::1:ff00:0, ref 1, valid 1
MC addr ff02::2, ref 1, valid 1
MC addr ff02::1, ref 1, valid 1
ND6:
reachable time 23241, base 30000
dad_transmit 3, retransmit_timer(NS) 1000 (mSecs)
link_mtu 0, max_mtu 0, hop_limit 64
flags 0, managed_flag 0, other_config_flag 0
send_router_solicit 0, solicit_sent_count 0, solicit_timer 0
send_rtr_advert 1, send_init_rtr_advert 0, time_since_last_ra_sent 2
rtr_adv_interval (cfg)(curr) 3(3), rtr_adv_timer 2, rtr_adv_sent_cnt 3
adv: default_lifetime 1800, reachable_time 0, retransmit_timer 0
(milisecs)
adv: link_mtu 1500, hop_limit 64, managed_flag 0, other_config_flag 0
Brocade#
VLAN ID greater
than 255 can now
be used.
show ipv6
interface
loopback 2
?
Interface Loopback 2 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::205:ff:fe05:5 [Preferred]
Global unicast address(es):
2000:2:2:2::20 [Preferred], subnet is 2000:2:2:2::/64
2000:2:2:2:: [Anycast], subnet is 2000:2:2:2::/64
Joined group address(es):
ff02::1:ff00:20
ff02::1:ff05:5
ff02::16
ff02::d
ff02::1:ff00:0
ff02::2
ff02::1
Port belongs to VRF: default-vrf
MTU is 1500 bytes
ICMP redirects are disabled
No Inbound Access List Set
Outbound Access List
OSPF enabled
"Port belongs to
VRF" information is
added.
show command output differences between 07.4.00 and 08.0.xx
FastIron Ethernet Switch Software Upgrade Guide
53-1003632-02

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English