Brodit ProClip 854857 - Installation Instructions; Step 1: Surface Preparation and Initial Attachment; Step 2: Securing the Angled Edge; Step 3: Hooking the Upper Edge

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
covers on the ProClip. Press the angled edge on the lower part of the ProClip into the gap between the
compartment and the surrounding frame.
2. Pull the lower part of the ProClip toward you so the angled edge hooks properly around the frame surrounding
the compartment.
3. Press downward on top of the ProClip so the angled upper edge hooks under the frame surrounding the
compartment.
4. The ProClip is in place.
2(2)