d. Always place the converter in an environment that is:
- Well ventilated.
- Not exposed to direct sunlight or heat sources.
- Out of reach of children.
- Away from water moisture, oil or grease.
- Away from any flammable substance.
e. When the circuit breaker switch for overload protection is tripped
The circuit breaker trips to the OFF position and opens the circuit if the converter is over
loaded with too much power from the connected appliances. If this happens unplug the
converter from the wall outlet and remove all connected appliances. Wait a few minutes.
Then re-connect the appliances. Ensure that the appliances are turned off before you
connect them. Ensure that their combined rated power of all appliances does not exceed the
power rating of the converter. Then connect the converter to the power supply. Switch on the
converter and the connected appliances one by one.
f. When one of the circuit breakers of one of the USA Nema output is tripped
The circuit breaker of one of the US Nema outputs is triggered when the corresponding
output is loaded with more than the maximum permissible 15 amperes. If this happens
remove the connected device from the corresponding socket. Press the circuit breaker to
reactivate the corresponding output. Now you can use the output again. Before reconnecting
a device to the output, make sure it is turned off. Ensure sure as well that the combined load
of all appliances connected to the output won't exceed 15 amperes.
7
High Eciency Step Down Converter
Instruction Manual
To Next Page
Loading...