Brookfield PFT Powder Flow Tester - 1.6 Back Panel

AMETEK Brookeld Page 11 Manual No. M09-1200-F1016
I.6 Back Panel
 


j
k
l
m
n
RS232 USB
TEMP HUMIDPOWER
%RH
1. KEEP ALL PACKAGING MATERIAL
for future transit. The PFT must be
shipped via FREIGHT!
2. The Trough, Trough Shipping Foam and
Vane Lid must be installed into the PFT
prior to shipment. (Refer to the manual
for details.)
3. Contact Brookfield Engineering for
replacement packaging.

Figure I-2: Back Panel
1. USB Type B port
Use with USB Cable P/N DVP-202 to connect instrument to a computer. Cable USB 2.0
A Male to B Male.
2. RS-232 Serial Port
Use with RS-232 Cable P/N DVP-80 to connect instrument to a computer.
3. Temperature Probe Plug
4-Pin plug. Use with Temperature Probe P/N DVP-94Y.
4. Humidity Sensor Plug
3-Pin plug. Use with P/N PFT-607Y.
5. Power entry module:
ON/OFFswitch-fused(seeUtilitiessection)Voltage90-265VAC.
6. Hand Hold locations for handling instrument. Recommend two people for movement
of instrument due to heavy weight.
7. Label with the instructions for shipment of unit by freight carrier.