Need help?Do you have a question about the BROSA Gas Lift Bed Frame Base and is the answer not in the manual?
General| Category | Indoor Furnishing |
|---|---|
| Gas Lift Mechanism | Yes |
| Assembly Required | Yes |
| Type | Bed Frame Base |
| Color | Black |
| Compatible Mattress Size | Queen |
The main headboard component of the bed frame.
The side panels of the bed frame.
The set of wooden slats for the mattress support.
The front panel of the bed frame.
Boards placed on support bars for the base.
Bars that support the floor boards.
Bars to secure the mattress in place.
Connect the headboard to the front of both sideboards.
Connect the back of both sideboards to the footboard.
Secure the assembled frame structure by tightening bolts.
Lift the L-shaped bar to align the threaded rod with the gas lift strut hole.
Use the removed nut to secure the gas lift strut.
Unfold the slat set to its full size.
Place the slat set on a level surface with the underside facing up.
Secure the slat set to the middle metal bar using bolts, washers, and nuts.
Place the slat set onto the gas lift arms.
Insert bolts from the top into corresponding holes.
Secure bolts from the bottom using flange nuts and tools.
Insert the wooden support bars into their designated slots.
Position the floor boards on top of the wooden support bars.
Push the slats down with assistance.
Rotate rubber blocks on retainer bars to a vertically longer position.
Attach mattress retainer bars to the front end of the slat frame.
To Next Page
