Brother GT-3 Series - Sensor for the CL Drive Cam

6. Replacing Parts
6-1-24. Sensor for the CL Drive Cam
Required Tool
・Phillips screwdriver
Disassembling
1. Remove the Maintenance Unit. (Refer to “6-1-16. Assembling / Disassembling of the Maintenance
Unit”. )
2. Remove the Screw (2) that fixes the Cap Sensor Holder.
(1)
(2)
(4)
3.
Remove the
Connector (3) and the Sensor (4).
(4)
(3)
Replacemen
t & Assembling
1. Replace to the new Sensor (4) and connect the Connector (3).
2. Confirm that the claws (5) of the Sensor are fixed properly.
(5)
Inlet of the connector
(4)
GT-3 Series
194