Brother GT-3 Series - Page 335

6. Replacing Parts
5.
Remove the t
wo FFC Connectors (7) that connects to the Carriage PCB Assy (6).
Remove all the seven clamps (8) to fix the FFC Cable and then remove the FFC Cable.
<Note>
Refer to the page “How to connect/disconnect the FFC Connector” in “6-2-18. Replacing the Carriage
PCB Assy” when you handle FFC Connectors.
GT-3 Series
326
6. Remove the one Connector (9) that connects to the Maintenance PCB Assy.
Remove the two Cord Clamps (10) and disconnect the Harness.
(8)
(8)
(6)
(8)
(7)
(
9
)
(10)