(14) Wear the gloves, and wet both sides of a Clean Applicator with the Wash Liquid. <Note>
Use only the Wash Liquid included to wet the Clean Applicators; using other liquid will cause damage to
the Print Heads and Rubber caps.
(15) Use the one side of wet Clean Applicator to clean the front side of the Wiper Blade.
When cleaning back side of Wiper do not
apply excess pressure but slightly swabbing
and wiping gently. Excess pressure
can
remove rubber from holder.
(16) Use the other side of the wet Clean Applicator to clean the backside of the Wiper Blade.
When cleaning back side of Wiper do not
apply excess pressure but slightly swabbing
and wiping gently. Excess pressure
can
remove rubber from holder.
(17) Wet other two Clean Applicators and use them to remove ink or dust from the Print Head Caps. Use
one side of the Clean Applicator to clean one Print Head Cap.
<Note> Do not use the dry Clean Applicator; it cannot clean ink or dust. It may damage the Print Head
Caps.
(18) Insert the Wiper Cleaner Cassette straight into GT-541.
<Note> Do not touch the Clearance Sensor (the bar above the Wiper Cleaner Cassette); it may cause a
malfunction.
To Next Page
Loading...
