Brother GTX-4 - Page 20

11
Setu
p
of the
p
rinte
r
5.
Tuck the extra cable into the space as shown in area (e) for the
color side.
To eliminate the slack of the flat cable on the resin cover side,
hold the cable down by using a clip as shown in a.
Hook the two claws of the resin cover to mount the cover.
6.
Remove four caps of the head.
Check that the head and the marker of each tube are matched
and connect the tubes one by one from back to front of the
machine by rotating the nut until it stops.
IMPORTANT
Do not rotate the nut as illustrated in (f). It could
disconnect the tube and leak the contained ink.
Be sure to remove the caps attached to the
head before connecting.
M4
4
3
2
1
M
C
Y
K
C3
Y2
Bk1
M4
C3
Y2
Bk1
(f)
X0012
(e)
①
①
X0123