Brother GTX pro Bulk - Main body and tank unit connection

7
Setu
p
of the
p
rinte
r
Tube connection
IMPORTANT
Make sure the main body and tank unit are in
place before connecting the tubes.
1.
Loosen the screws of the right cover of the main body unit and
remove the cover.
2.
Mount the bracket with screws.
TIPS
If the bracket comes off, insert it into the third
groove from the tube end.
3.
Remove the screw binding the tube and apply maintenance
solution to the tip of the tube.
TIPS
Perform steps 3 and 4 for each tube.
X0300
X0299
2
X0297
Main body and tank unit connection
X0356
A
lign with the corner
A
lign with the front side
A
lign with the corner
A
lign with the front side