Brother GTX pro - When you dispose of the machine; Required Tools for Machine Disposal; Printer Disassembly for Disposal

2
Pre-treat application to garment Dark & Light
 Dark 30 Grams 1:1
 Medium 24-27 Grams 1:1
 Light 14-17 Grams 1:1
This mixing ratio might vary due to the type of garment which is used. Use your
experience!
Don’t forget that you have to define a surface of 14 X 16 inches [35 X 40 cm] with
your Pre-Treatment machine to weigh the amount of spray, with a scale, after
applying the Pre-Treatment liquid on a T-shirt!
Heat Press Settings for Pre-Treatment Drying
 45seconds @ 170c
 Use Teflon Sheet on the heat press to cover the Pre-treatment and clean the
Teflon surface every 5 T-shirts min or purchase a heat press Teflon top cover
and save you time placing Teflon sheet on product.
Heat Press Settings for Ink Curing
 Heat Press 45seconds @ 170c
 Use Teflon Sheet on the heat press to cover the Pre-treatment and clean the
Teflon surface every 5 T-shirts min or purchase a heat press Teflon top cover
and save you time placing Teflon sheet on product.
 Tunnel Dryer 3.30 minutes @ 160c
 Check the REAL Temperature with a Probe or with Strips to be sure that you are
safe for the wash ability!
Never Turn the Power Off
 The Brother GTX pro should ALWAYS be left with Power ON
 NEVER shut OFF the printer except if requested by the display message
only!
 Power is requested to perform the needed recirculation of the inks every
day