WHEN NOT USING PRINTER FOR A LONG PERIOD OF TIME
!
!
INK & SOLUTIONS STORAGE
HOW TO EXTRACT A LOG FILE FROM THE PRINTER?
OKOK
MENUMENU
Insert a USB stick in the front slot of the printer to be able to copy the log file
Go to the menu:
Maintenance > Log copy to USB >
The printer can be used through normal procedure
after the storage period, by performing the following
maintenance tasks before:
• Please empty the Waste ink Tank.
• Check the amount of Cleaning Solution in the cleaning
liquid tank, and refill the tank if its amount is below the
proper level.
• Stir the white ink if a white ink cartridge stirring mes-
sage is displayed on the operation panel screen.
• Clean toroughly the Nozzle Guard, Wiper, Suction
Cap and Exhaust Cap.
• Print out a Nozzle Check pattern for White and CMYK.
• If a non-firing nozzle is found: Perform Head Cleanings,
run the Nozzle Check prints and verify the result again.
Continue same process until the blocked nozzles are ALL
OPEN again!
CMYK & White inks, Cleaning Solution, Maintenance Solution &
Pretreatment Solution should be stored at a temperature range
between minimum 0° and 40° maximum!
> When the printer will not be used for a prolonged period of time, take appropriate
procedures before storing the printer depending on storage period or conditions.
> DO NOT turn the printer OFF, otherwise, the printer may be DAMAGED!
!
> REPEAT THE SAME WHOLE PROCEDURE EVERY 2 WEEKS!
EVERY 2 WEEKS OF INACTIVITY
> Be carefull NOT to go below Zero degree!
> Please ROTAT E the pouches boxes every week!
S
H
A
K
IN
G
5
cm
1 M
in
u
te
MNT
CLEANINGS
S/N: M9933069
Firm Ver 1.32.0002
Prints: 771
15/01/2021 10:41:07
S/N: M9933069
Firm Ver 1.32.0002
Prints: 770
15/01/2021 10:39:15
Nozzle Tests
EMPTY
LEVEL
11
To Next Page
Loading...
