Brother GTX600 Series - Waste Tank Management; Waste Ink Tank and Waste Water Tank; Emptying Wastewater and Waste Ink Tanks

10
WASTE TANK7
WASTE INK TANK & WASTE WATER TANK
1
EMPTYING THE WASTEWATER & WASTE INK TANKS
2
The 2 tanks must be set in the correct position like below.
The drain tubes should be located right above the tank holes.
A warning message will appear when the Waste Ink Tank or Waste
Water Tank is full. To verify which tank needs to be emptied, press the
right arrow button on the control panel.
WASTE
WATER
TANK
WASTE
INK
TANK
GOOD POSITION OF THE TANKS
WASTE INKWASTE WATER
TEMPERATURE & HUMIDITY RECOMMENDATIONS
5
To get the best out of your GTX600 printer,
please allow your workshop to stay within the
recommended range of Temperature and
Humidity:
> Between 64° and 86° F for operating
temperature.
> Humidity is regulated INSIDE the machine
via the built-in humidifier.
18
MIN
TEMPERATURE
30
MAX
C
°
°
HUMIDITY
REGULATED
INSIDE PRINTER
GTX600 H%HUMIDITY
REGULATED
INSIDE PRINTER
AUTOMATIC
18
MIN
TEMPERATURE
30
MAX
C
°
°
MIN
MAX
AUTOMATIC
TEMPERATURE HUMIDITY
Scan QR Code
for Emptying the
Wastewater and
Waste Ink Tanks
Video