6-33
Precautions to keep good printing quality/use printer over the long term
(6) Remove each tube from the print head to be replaced with a new one. Then attach each of the new caps which are
removed from a new print head to each tube, while exercising care to prevent any ink from being spilled.
<IMPORTANT>
Care is needed in preventing any ink from being spilled from each tube. If the ink is dripping, wipe off the dripping ink.
<NOTE>
For a proper work operation, be sure to wear the printer-provided gloves.
(7) Remove the latch on the carriage board cover and open the cover.
(8) Remove the head board of the corresponding print head.
<CAUTION>
Be sure not to touch other boards.
(9) Remove the hook and clamp and disconnect the flat cable.
X100
Latch
Head board
Head board
Flat cable
Clamp
Hook
Tube
Cap
Tube
Print head
To Next Page
Loading...
