Brother GTX600NB - Cleaning and Replacing Maintenance Parts

6-56
Precautions to keep good printing quality/use printer over the long term
6-2-2. Cleaning and replacing maintenance parts
Clean the maintenance area, if it is dirty, when replacing the flushing foam.
(1) Prepare a waste cloth.
<IMPORTANT>
 Please complete the task within 15 minutes, in order to prevent the print heads from drying up.
 Then, the head cleaning will be performed to prevent any ink from drying up.
(2) Unlock the upper left-hand-side cover and top cover and open them.
(3) Wipe the red frame part with waste cloth.
<IMPORTANT>
 Please complete the task within 15 minutes in order to prevent the print heads from drying up.
 Be sure to use a clean waste cloth. Using a cloth with pretreatment may lead to non-ejection.
 Do not touch other parts such as springs and caps when wiping part (a), as shown in the photo. If you touch the spring, in
particular, it may come off.
 Do not rub the parts strongly. Doing so may cause the parts to bend.
 Do not put the wiped ink waste in the wiper cleaning tank.
(4) Close the upper left-hand-side cover and top cover.
<NOTE>
 Dispose of any waste resulting from the cleaning in accordance with applicable laws and ordinances.
Keyhole
Keyhole
(a)
Do not put the ink-smeared waste in
the cleaning solution tank.