6-59
Precautions to keep good printing quality/use printer over the long term
X1047
(6) With a clean stick R, clean the surrounding area of nozzle surface of print head.
<IMPORTANT>
Be sure not to bring the clean stick R into contact with the nozzle surface.
The used clean stick R should be disposed of, and should not be reused.
Do not rub the parts strongly, which may scrape the water repellent film.
(7)
Close the right-side cover and press in response to the instructions on the screen.
<NOTE>
Dispose of any waste resulting from the cleaning in accordance with applicable laws and ordinances.
<TIPS>
Then, the head cleaning will be performed to prevent any ink from drying up.
Because the cleaning cup will be reused, rinse it in clean cleaning solution and store it in a safe place.
Cleaning conditions
Pre-cleaning state
Post-cleaning state
X1001
Nozzle surface
Surrounding area of
nozzle surface
Cleaning area
Cleaning
prohibited
To Next Page
Loading...
