6-61
Precautions to keep good printing quality/use printer over the long term
(3) Pull out the tube toward you from each tank and dispose of the waste ink and waste water in the tanks.
Place a receiving tray or the like under the other end of the tube (when removed) from the waste ink tank so that the waste ink
spilled from the tube will not be discharged onto the floor, etc.
<IMPORTANT>
Waste ink tank and waste water tank can weigh as much as 10 kg (22 lb).
Be careful when pulling them out.
<NOTE>
Dispose of the waste ink properly as water-based waste fluid in accordance with applicable laws and ordinances.
(4) Check the direction of the tank holes and install each tank as shown on the label.
Insert each tube into the tanks after installation.
<IMPORTANT>
Be sure to push the tanks into the end.
Install the tanks so that the hole of each tank is directly below the tube.
The tanks may not be detected if the orientation is wrong.
Make sure that the tubes are inside the respective tanks.
Be careful not to bend the tubes excessively.
Otherwise the waste ink may have difficulty flowing through the tube.
(5) Close the lower left-hand-side cover.
Waste ink tank
Waste water tank
Waste water tank
Waste ink tank
To Next Page
Loading...
