Brother GTX600NB - Initial Installation of Printer; Level Adjustment

3-3
Installation and preparation
3-2. Initial installation of printer
Please refer to the Setup Manual for the following initial installation procedures:
 Main tank unit
 Print switch
 Waste ink tank/Waste water tank
 Humidifier pipe
 Carriage belt tension adjustment
 Humidifier water supply tube
 Water supply tank (optional item)
 Turning on the power
3-2-1. Level adjustment
Prepare a level gage and a 1.4-in. (35-mm) wrench.
(1)
On the operation panel, press
, and move the platen toward the front of the printer.
(2) Place a level gage on the top surface of the platen.
(3) Adjust the level by rotating the lower nuts that secure the legs (4 points) so that the main unit is set horizontally level
while checking the level gage.
<IMPORTANT>
 Adjust so that the adjusters protrude 4.9 in. (125 mm) or less from the bottom of the frame.
4.9 in. (125 mm)
or less