3-9
Installation and preparation
(6) Push the carriage in the maintenance direction after the carriage comes in contact with the lever.
<IMPORTANT>
Make sure that the protrusion on the cap touches the side of the print heads when pressing the carriage in the maintenance
direction. Non-ejection may occur if the carriage comes in contact with the nozzle surface of a print head.
(7) Pull out the pin inserted in A and turn the lever clockwise until the lever comes in contact with the pin inserted in B.
Print head capping will be performed correctly in this state.
<IMPORTANT>
Make sure that the lever will not come in contact with the nozzle surfaces of the print heads when turning the lever.
A print head may rise if you press the protruding part of the cap strongly against the nozzle surface of a print head. Do not
forcibly turn the lever in that case, and start over the work from the beginning.
(8) Pull out the pin inserted in B and attach the cover with the two screws.
<TIPS>
Return the pins to the storage position.
(9) Turn on the power and restart the printer as soon as the power failure is restored.
<IMPORTANT>
For this reason, be sure to restart the printer and perform the head cleaning after activation.
Screw
Cover
To Next Page
Loading...
