3-24
Installation and preparation
3-6-1. Initial settings after head replacement
Set V-rating after replacing the print head or completing the setup procedure.
(1) Make sure that the printer and PC are connected via a LAN cable.
(2) On the PC, from [All Programs] in the Start menu, select the "GTX-6 Maintenance" from "Brother GTX-6 Tools".
(3) After the window shown below appears, select [Initial settings after head replacement] and click [Next].
(4) Perform the required operation by following the on-screen instructions in the dialog box.
After the adjustment is completed, the currently displayed screen will go back to the window mentioned above.
To Next Page
Loading...
