Brother GTX600NB - When Using Adobe Photoshop

4-11
Creating print data
4-3-2. When using Adobe Photoshop
In Photoshop, configure the settings mentioned below:
 Color setting
As required, perform the following procedures:
 Create print data (ARX6 file)
 Use the color palette in Useful Tools.
 Replace RGB=255 with RGB=254
<TIPS>
 For an image created in the CMYK color mode, select [Image] > [Mode] in the menu bar, and change the color to the RGB color
(sRGB). In order to edit an image, select [Image] > [Adjustments] in the menu bar and edit it, or edit it by means of the image
quality improvement of the printer driver.
・In the case of print data using white ink ☞"4-4-10. Set up the image quality >>P.4-36"
・In the case of print data using color ink and black ink only ☞"4-5-6. Set up the image quality >>P.4-46"
 For this printer, it is recommended to use Photoshop CC. The display screen is described in Photoshop CC.
Color setting
(1) In the menu bar, select [Edit] > [Color Settings].
(2) Establish the settings of [Color Settings] as follows:
[Working Spaces]
 [RGB]: [sRGB IEC61966-2.1]
[Conversion Options]
 [Engine]: [Adobe(ACE)]
 [Intent]: [Relative Colorimetric]
[Color Management Policies]
 [RGB]: [Convert to Working RGB]
 [CMYK]: [Convert to Working CMYK]
 [Gray]: [Convert to Working Gray]
 [Profile Mismatches]: Mark the [Ask When Opening] and [Ask When Pasting] checkboxes.
 [Missing profiles]: Mark the [Ask When Opening] checkbox.