Brother HE-800A - Page 90



HE-800A
13. CHANGING FUNCTIONS USING THE DIP SWITCHES
82
DIP switch B
No. ON/OFF Setting items Default
ON -
1
OFF -
OFF
ON -
2
OFF -
OFF
ONޔONޔON
Panel DIP switches B - No. 7 and No. 8 are enabled.
ONޔONޔOFF Work clamp size: 7.3 u 36.0 mm (Sewing area: 6.0 u 32.0 mm)
ONޔOFFޔON Work clamp size: 7.3 u 24.5 mm (Sewing area: 6.0 u 20.0 mm)
ONޔOFFޔOFF Work clamp size: 6.8 u 36.0 mm (Sewing area: 5.4 u 32.0 mm)
OFFޔONޔON Work clamp size: 6.8 u 24.5 mm (Sewing area: 5.4 u 20.0 mm)
OFFޔONޔOFF
Panel DIP switches B - No. 7 and No. 8 are enabled.
OFFޔOFFޔON Work clamp size: 5.4 u 19.0 mm (Sewing area: 4.0 u 15.0 mm)
3ޔ4ޔ5
OFFޔOFFޔOFF
Panel DIP switches B - No. 7 and No. 8 are enabled.
OFFޔOFFޔOFF
ON
Needle plate size: 5.4 mm
(Max. needle zigzag feed width = 4.0 mm)
6
OFF
Needle plate size: 7.3 mm
(Max. needle zigzag feed width = 6.0 mm)
OFF
ONޔON Work clamp size: 7.3 u 47.0 mm (Sewing area: 6.0 u 40.0 mm)
ONޔOFF Work clamp size: 6.8 u 47.0 mm (Sewing area: 5.4 u 40.0 mm)
OFFޔON Work clamp size: 5.4 u 24.5 mm (Sewing area: 4.0 u 20.0 mm)
7ޔ8
OFFޔOFF Work clamp size: 5.4 u 36.0 mm (Sewing area: 4.0 u 32.0 mm)
OFFޔOFF
* If the programs are initialized when Nos. 3, 4 and 5 are set to OFF, OFF and ON respectively, the initial value for
parameter No. 02 - Cutter size will be set to 6.0 mm. (Normal default value is 13.0 mm.)