Brother HE-800A - Cutter Mechanism ･･････････････････････････････6

1. MECHANICAL DESCRIPTIONS
HE-800A
6
1-6. Cutter mechanism
1. When a cutter ON signal is input, the cutter solenoid (1) operates.
2. A cutter link bracket (2) is secured to the end of the plunger, and it turns the cutter driving arm (4) via the cutter
driving link (3).
3. The cutter driving kink (5) that is secured to the end of the cutter driving arm (4) is moved up and down.
4. The driving shaft holder assembly (6) is linked to the cutter driving link (5), and this causes the cutter driving
shaft (7) that is connected to the driving shaft holder assembly (6) to move up and down.
4052Q