Brother HE-800C - Installing the Flange Nut; Installing the Bed Base

HE-800C
3. INSTALLATION
6
3-3. Installing the flange nut
Install the four flange nuts (1) to the
underside of the work table.
3-4. Installing the bed base
1. Place the bed base (1) on top of the
work table, and insert the four collars
(2).
2. Provisionally tighten the four flange
nuts (4) onto the four bolts (3), and
then position the bed base (1).
3. Install the bed base (1) with the three
flat washers (5) and wood screws (6),
and then install the two rubber caps
(7).
4. Remove the four bolts (3).
5. Set the magnet (8) in the position
shown in the illustration.
4737M
4069M