HE-800C
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
35
5-4-1. Parameter list
・Parameters that are not applicable to a particular program will be skipped and not displayed.
・The allowable setting range for some parameters may vary from the range specified, depending on the settings of other
parameters. (Refer to “5-4-4. Main restrictions when setting parameters”.)
No. Setting items Setting range Unit Initial value
01 Sewing pattern 1-20: Buttonhole stitch
21: Straight tack stitch
1 1
1: Rectangle
2: Radial
3: Round
4: Radial-rectangle
5: Round-rectangle
6: Eyelet-rectangle
7: Rectangle-radial
8: Round-radial
9: Eyelet-radial
10: Rectangle-round
11: Radial-round
12: Eyelet-round
13: Rectangle-taper tack
14: Radial-taper tack
15: Round-taper tack
16: Eyelet-taper tack
17: Rectangle-tack
18: Radial-tack
19: Round-tack
20: Eyelet-tack
21: Straight bar tack
02
Length of the hole 4.0–32.0 mm
However, it must be less than
the sewing area.
0.1 13.0
(*1)
03
Correction of cutter X position -0.50–0.50 mm
0.05 0.00
04
Cutter X space
-0.40–1.00 mm
0.05 0.40
(*1) If the work clamp dimensions have been set to 5.4x19 mm, the initial value for the length of the hole will be 6.0 mm.
To Next Page
Loading...
