HE-800C
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
45
5-8. Double cutting function
During sewing, the cutter can be operated twice in order to sew button holes which are larger than the cutter size.
Use this function when you would like to sew a variety of different sewing shapes without replacing the cutter.
1
Setting number of cutter operations
Check that memory switch No. 502 is set to ON while referring to “7-2. Setting memory switches”.
2
Enter the cutter size.
Select memory switch No. 501 while referring to “7-2. Setting memory switches”, and then enter the cutter size.
(Initial value: 13.0)
3
Enter the length of the hole.
Enter the length of the hole while referring to “5-4. Program setting method”.
Press the ENTER key to confirm the changed setting.
4
Sewing
Carry out a test sewing while referring to “6-1. Automatic sewing (Automatic sewing mode)”.
If double cutting is not possible because of the settings for the cutter size and the length of the hole, a warning screen
will be displayed and sewing will not be possible.
* The cutter size and the length of the hole are
the same, the number of operations will be
only one, even if the double cutting function
is turned on.
4317B
4229B
4229B
4215B 4216B
or
4319B
4218B
Length of hole
4318B
Cutter size
1st
2nd
To Next Page
Loading...
