Brother HE-800C - 7 Using the Sewing Machine (Operation Panel: Advanced Operation); Using Cycle Programs

7. USING THE SEWING MACHINE (OPERATION PANEL: ADVANCED OPERATION)
HE-800C
53
7. USING THE SEWING MACHINE
(OPERATION PANEL: ADVANCED OPERATION)
7-1. Using cycle programs
The sewing patterns which have been registered in independent programs (P01 – P50) can be combined to register “cycle
programs” so that they can be run continuously. When sewing the sewing patterns in a certain order, it can be useful to record
them in a cycle program beforehand.
Cycle programs
Max. no. of recordable programs 9 (C1 - C9)
Max. no. of steps 19 (the same independent program can be selected several times)
Program example
The following shows an example of storing a cycle program into cycle program C1 that consists of three steps of independent
program P01 with cutter operation on, and one step of independent program P03 with cutter operation off.
Example: Setting contents for cycle program C1
Step number Step 1 Step 2 Step 3 Step 4
Independent program
number
P01 P01 P01 P03
Cutter operation Yes Yes Yes No
1
Press either the AUTO key or the TEST key.
(Either key can be pressed at this time.)
2
Select cycle program number C1 (1).
The program number (1) changes in the order shown in the illustration
each time the key is pressed.
(The key changes the order in the opposite direction.)
4227B
4890M
Independent program
Cycle program
4787M