Brother HL-1030 - Page 81

CHAPTER 4 TROUBLESHOOTING
4-7
Error message Action
MEMORY FULL
• Press the panel button to print the data remaining in the
printer.
• Reduce the print resolution or reduce the complexity of your
document.
(For HL-1250 Only)
· Expand the printer memory by adding a commercially available
SIMM memory. Refer to ‘How to add extra Memory’ in
Chapter 2.
RESOLUTION ADAPTED
(The printer has printed the
document at a reduced
resolution.)
• Reduce the complexity of your document before you print to
prevent automatic reduction of the resolution.
(For HL-1250 Only)
• Expand the printer memory by adding a commercially
available SIMM memory. Refer to ‘How to add extra
Memory’ in Chapter 2.
FUSER MALFUNCTION
• Turn the power switch off, wait a few seconds and then turn it
on again.
• Leave the printer for 10 minutes with power on. If the error
occurs again, consult your dealer.
LASER BD MALFUNCTION
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.
SCANNER MALFUNCTION
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.
D-RAM ERROR
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.
NV-RAM ERROR
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.
MAIN MOTOR ERROR
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.
ENGINE INTERFACE ERROR
• Turn the power switch off, wait a few seconds and then turn it
on again. If the error occurs again, consult your dealer.