Brother HL-1670N - Set Color to Palette

8/2/2010
CHAPTER 3 "PCL5C" - 10
3. COLOR PALETTES
3.1. Set Color #1
Command
ESC*v#A (27)(42)(118)#(65) <1Bh><2Ah><76h>#<41h>
Range = -32767 ~ 32767
Default value = 0
y This command sets the red value in the palette. Use the Set Color to Palette command to set the value
y The value range to be set varies depending on the specified black/white reference.
3.2. Set Color #2
Command
ESC*v#B (27)(42)(118)#(66) <1Bh><2Ah><76h>#<42h>
Range = -32767 ~ 32767
Default value = 0
y This command sets the green value in the palette. Use the Set Color to Palette command to set the value.
y The value range to be set varies depending on the specified black/white reference.
3.3. Set Color #3
Command
ESC*v#C (27)(42)(118)#(67) <1Bh><2Ah><76h>#<43h>
Range = -32767 ~ 32767
Default value = 0
y This command sets the blue value in the palette. Use the Set Color to Palette command to set the value.
y The value range to be set varies depending on the specified black/white reference.
3.4. Set Color to Palette
Command
ESC*v#I (27)(42)(118)#(73) <1Bh><2Ah><76h>#<49h>
Range = 0 ~ (2
n
- 1) (The value n is specified by the Bit/Index setting in the Set PCL Color Setting
command.)
Default value = 0
y This command sets the red, green and blue values which are set by the Set Color #1, #2, #3 commands in the
palette.
y When an out of range value is set, it is ignored in the palette.
y This command sets the value which was set by the Set Color #1, #2, #3 commands to 0.