8/2/2010
CHAPTER 2 "PCL" - 17
4.1.2. Media type selection
Esc&n# (27)(38)(110)# <1Bh><26h><6Eh>#
# stands for the media type of paper to be used.
Values for # correspond to the media type shown in the table.
Model
HL-
2070N/5240/5250DN/
5270DN/5280DW/
2150N/2170W/
5340D/5350DN/5370
DW/5380DN
HL-
4040CN/4050CDN/
4070CDW/3040CW
/2250DN/2270DW
HL-
4140CN/41
50CDN/45
70CDW
6WdPlain Set as Plain Paper.
8WdRegular
5WdThin Set as Thin Paper.
6WdThick Set as Thick Paper.
7WdThick2 Set as Thicker Paper.
5WdBond Set as Bond Paper.
13WdTransparency Set as Transparent Paper.
10WdEnvelopes Set as Envelope.
9WdEnvthick Set as Thick Envelope.
8WdEnvthin Set as Thin Envelope.
9WdRecycled Set as Recycled Paper.
9WdPostcard Set as Post Card.
6WdLabel Set as Label.
7WdGlossy Set as Glossy
4.1.3. Output tray
Esc&l#G (27)(38)(108)#(71) <1Bh><26h><6Ch>#<47h>
# denotes the output tray.
1: Select the printer output tray.
3: Select #1 bin. (CT:HL-8050N)
4: Select #2 bin.
5: Select #3 bin.
6: Select #4 bin.
7: Select #5 bin.
8: Select #6 bin.
9: Select #7 bin.
10: Select #8 bin.
11: Select #9 bin.
12: Select #10 bin.
100: Select the finisher tray (HL-3260N)
This command selects the specified output tray.
This command is ignored when the specified tray is not available.
The PJL OUTBIN command is ignored when this command is executed.
If the printer has data to print when this command is executed, the command is valid from the next page
immediately after the data is printed.
To Next Page
Loading...
