CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-6
NOTE:
When replacing/re-assembling the pad holder ZLh ASSY, remove the old grease and apply a
suitable amount of grease referring to the figure below;
Fig. 4-5
(3) Turn the paper cassette upside down, then remove the tray cover film by peeling it
carefully from the underside of the cassette.
(4) Remove the TORX pan B M3x8 Taptite screw and remove the paper tray cover from the
front of the cassette.
Fig. 4-6
NOTE:
• The cover film must not be reused after it has been removed. Always replace it with a new
one.
• The screw securing the paper cassette cover indicated RED in the figure above is very
special. When disassembling/re-assembling the screw, you need a special screw driver.
Refer to the parts reference list.
Paper cassette
Paper pick-up roller
Taptite, TORX pan B M3x8
Tray cover film
Grease: Molykote PG-662
(1 rice-grain size)
Paper tray cover
Paper cassette
To Next Page
Loading...
