CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-33
!
CAUTION:
• Never touch the surface of the halogen heater lamp.
• When securing the screw to assemble the halogen lamp connector plate, ensure you use
the plastic jig as shown in the figure below to avoid damaging the edge of the halogen
heater lamp.
Fig. 4-54
(12) Lift and remove the heat roller 25 HE. The HR gear 34 HE will also come off.
(13) Remove the HR bearing 25 from the left hand end of the heat roller 25. To remove the HR
bearing 25 at the gear side, first remove the two washers, then remove the bearing.
Fig. 4-55
!
CAUTION:
Heat roller 25 HE
Heat roller bearing 25
Heat roller gear 34 HE
HR bearing 25 HE
Washer
Washer
Screw, pan (washer) M 2.6x6
Halogen lamp
connector plate
Plastic jig
Halogen heater lamp
To Next Page
Loading...
