CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-35
NOTE:
• When re-assembling the heat roller 25 HE to the FU frame upper, place the two projections
at the right hand side of the roller onto the bosses on the frame as shown in the figure
below.
Fig. 4-56
• When re-assembling the heat roller 25 HE to the FU frame upper, ensure you do not
damage the heat roller 25 HE with the four pick off fingers on the FU frame upper.
Fig. 4-57
Heat roller 25 HE
FU frame upper
Pick off fingers
Pick off fingers
Heat roller gear 34
HR bearing 25
Heat roller 25 HE
(projection)
(boss)
To Next Page
Loading...
