Brother HL-1870N - Page 146

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-39
NOTE:
When re-assembling the thermistor to the FU frame upper, ensure the direction of the
thermistor is correct referring to the figure below;
Fig. 4-64
(23) Remove the B 2.6x10 Taptite screw to remove the idle gear 13H. Hold slightly up the right
end of the eject roller and then remove the left end of the roller from the hook first, then
remove the eject roller from the FU frame upper.
NOTE:
When removing the left end of the eject roller, align the protrusion of the hook of the frame with
the concave part of the roller, and then pull the roller through underneath the protrusion.
Fig. 4-65
FU frame upper
Idle gear 13H
Eject roller
Thermistor
Taptite, cup B M3x12
FU frame upper
Taptite, B 2.6x10
Concave part of the roller
Thermistor