Brother HL-1870N - Page 156

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-49
(11) Remove the four cup S tite 3x6 screws and disconnect the harness to remove the main
motor ASSY from the drive sub ASSY A.
Fig. 4-77
(8) Place the main frame so that the drive unit side is at the right as the figure shown below.
(9) Remove the two bind B M4x10 Taptite screws.
Fig. 4-78
Main motor ASSY
Drive sub ASSY A
Main frame
Solenoid unit
Taptite, bind B M4x10
Screw, cup S tite 3x6
Screw, cup S tite 3x6
Drive sub ASSY A
Fuser drive gear