HL-1850/1870N SERVICE MANUAL
2-13
(3) Place paper in the multi-purpose tray so it
touches the back of the tray and remains below
the limit mark.
Fig. 2-15
NOTE:
Note the following when placing paper on the multi-purpose tray:
• If the paper to be printed on weighs more than 135 g/m
2
(36 lbs), use the face up output
tray.
• Insert the leading edge of the paper first and push it gently into the tray.
• If pre-printed paper is used in the multi-purpose tray, the paper should be inserted top
edge first with the printed side face up.
(4) Press and slide the paper width adjuster to fit the
paper.
Fig. 2-16
(5) Use the face down output tray for printing on
transparencies.
Fig. 2-17
(6) Change the settings in the printer driver properties tab.
To Next Page
Loading...
