CHAPTER 5 BIP INTERNET PRINTING INSTALLATION
5-3
Brother Internet Print
Configuring the Brother Print Server
The print server can be configured using BRAdmin, by using a web browser, or
by using the TELNET command.
Print Server Configuration Checklist
Before configuring the print server to receive BIP jobs, be sure that the E-mail
server at the remote site (the receiving end) is configured to handle the TCP/IP
POP3, and SMTP protocols (SMTP is only required if the notification feature is
enabled).
1. Configure the POP3 server on the E-mail server at the remote site with a
mail account (Mailbox name) and password for the Brother print server
(generally, the mail account name will be the first part of the Email
address; for example, if you assign the Email address
emailprinter@xyz.com, then the mail account name would be
emailprinter).
2. Make sure that the print server is installed and running with TCP/IP
enabled and has a valid IP address assigned to it.
Because access to the E-mail server on most networks is usually restricted, you
may need to have your network administrator check the configuration and add
the mail account.
To Next Page
Loading...
