HL-2030/2040/2070N SERVICE MANUAL
Confidential
2-7
Follow the instructions for your operating system and interface cable type.
3.2 For Windows
®
Users
For USB interface cable users
CAUTION:
If the “Found New Hardware Wizard” appears on the PC, click the Cancel button.
(1) Make sure the USB interface cable is NOT connected to the printer, and then begin
installing the driver. If you have already connected to the cable, remove it.
(2) Click “Install Printer Driver” on the Menu screen.
(3) Select the USB Cable. Read the license agreement carefully. Follow the on-screen
instructions.
(4) When this screen appears, make sure the printer power switch is on. Connect the USB
interface cable to your PC, and then connect it to the printer. Click the Next button.
Fig. 2-6
(6) Click the Finish button.
For Windows
®
98/Me users: The setup is now complete.
For Windows
®
2000/XP users: Follow the instructions below for setting the PC as the
default printer.
For Windows
®
2000/XP users only (Setting your printer as the default printer.)
(1) Click Start, and then Printers and Faxes.
Fig. 2-7
(2) Select the icon of the appropriate printer.
(3) From the File menu, select Set as Default printer.
For Windows
®
2000/XP users: The setup is now complete.
To Next Page
Loading...
