Control panel
38
4
Make a note of the indication and report the error status to your dealer or a Brother authorized service
representative by referring to the above table.
Note
Make sure that the front cover is fully closed before you report a service call.
1
If this error occurs, turn the power switch off, wait a few seconds, and then turn it on again. Leave the printer for 10 minutes with the power on.
If the error occurs again, consult your dealer or Brother authorized service representative.
Table 1: LED indications while pressing Go button
LEDs
fuser unit failure
1
Laser unit failure Main motor failure Main PCB failure
Toner
Drum
Error
Ready
To Next Page
Loading...
