VI-23
(8) Press the CONTINUE switch to check the 2nd stage cassette.
TRAY 2 = A4 Appears when the cassette is set to A4 size.
TRAY 2 = LETTER Appears when the cassette is set to letter size.
TRAY 2 = NO Appears when no cassette is set.
CASSETTE ERROR!! Appears in case of error.
(9) Press the CONTINUE switch to check multi purpose tray.
MP TRAY Set paper on the MP tray.
MP TRAY OK!!
(10) Stuck sensor check
STUCK = LOW Appears when the stuck full sensor for the
standard output tray is off.
STUCK = FULL Appears when the stuck full sensor for the
standard output tray is on.
(11) Press the CONTINUE switch to check flash memory cards and the MIO.
CARD1 R/W START Checks reading/writing on Card 1 ID.
È
CARD1 R/W OK!! The flash card works correctly.
È
CARD2 R/W START Checks reading/writing on Card 2 ID.
È
CARD2 R/W OK!! The flash card works correctly.
È
MIO CHECK START The flash card works correctly.
È
RAM SIZE = 8M
È
Now initializing
È
LJ WAIT 001P T1
È
LJ READY 001P T1
(13) Turn off the power.
Note: The checks on and after (11) are carried out automatically, and if an error
is detected, on of the following messages will be displayed.
Checks can be resumed if the CONTINUE switch is pressed.
R/W ERROR CARD1 There is a problem in reading/writing from the
flash memory card 1.
R/W ERROR CARD2 There is a problem in reading/writing from the
flash memory card 2.
You can turn off the power when this message is
displayed. If there is no toner cartridge or paper, the
message "14 NO CARTRIDGE" or “CHECK TRAY”
will be displayed.
To Next Page
Loading...
