V-19
3.3 Service Mode
Service mode is a unique mode for the maintenance of the printer only, without the video
controller card. In this mode, you can check the operation status of the printer engine Off-
line and also carry out maintenance work for each of the printer components.
Procedure
1) Hold down the Mode, Set and
▼
buttons and turn the printer Power on.
2) Using the Font, Continue, Set and
▼
buttons, select the mode necessary for the
maintenance work from the test list shown in Table 5-2.
How to designate the necessary mode
1) Press the Set or
▼
button so that
service modes (a), (b) and (c)
show up in sequence to be
selected.
2) After selecting the desired mode,
execute the selected mode by
pressing the Continue button.
3) Press the Font button to exit the
mode.
SERVICE MODE
TEST PRINT
SERVICE MODE
NEXT CARE INFO
SERVICE MODE
FACTORY MODE
(a)
(b)
(c)
To Next Page
Loading...
