V-42
3.4.5 Initial Setting of Engine NVRAM
Implement the initial setting at the replacement of MCTL PCB after clearing the contents
of NVRAM.
<Purpose>
The number of images for each color will be reset when changing the MCTL PCB or
executing NVRAM INITIAL.
<Procedures of Setting>
1) Before replacing the MCTL PCB, confirm the contents of the NVRAM for the
following items.
“Factory Mode”
Code Subject Confirmation Value
43 MARGIN ADJUST Top Margin Set Value (Default in ordinary case)
43 MARGIN ADJUST Left Margin Set Value(Default in ordinary case)
44 LIFE PERIOD SET Life Period Set Value(Default in ordinary case)
45 LP TUNE UP Adjustment Value (“-3” in ordinary case)
45 THV TUNE UP Adjustment Value (“0” in ordinary case)
45 DBV TUNE UP Adjustment Value (“0” in ordinary case)
45 CBV TUNE UP Adjustment Value (“0” in ordinary case)
45 FBV TUNE UP Adjustment Value (“0” in ordinary case)
47 TOTAL PAGE SET Total Print Count
48 EACH IMAGE SET Image Count of 4 Colors
2) Execute 46 NVRAM INITIAL in the Factory Mode.
3) After implementing the NVRAM INITIAL, input the values obtained in procedure 1)
into the NVRAM to complete the settings.
To Next Page
Loading...
